• sales

    +86-0755-88291180

Raspberry Pi 1.14inch 1.3inch LCD - Pinouts User Guide

The mini PiTFT connects to the 'top' 2x12 headers on the Pi's 2x20 header connection. It uses the following pins:

  • 5.0V - Connected to the display backlight
  • 3.3V - Connected to the display power and also the STEMMA QT / Qwiic connector
  • GND - Ground for everything
  • SDA & SCL - I2C data for the STEMMA QT / Qwiic connector. Not used by buttons or display
  • GPIO22 - Used to turn the backlight on and off. If you never want to turn the backlight off, cut the small jumper on the bottom of the PiTFT to free up GPIO22
  • GPIO23 & GPIO24 - Connected to the two front buttons. These pins have 10K pullups to 3.3V so when the button is pressed, you will read a LOW voltage on these pins
  • SCK, MOSI, CE0 & GPIO25 - These are the display control pins. Note that MISO is not connected even though it is a SPI pin because you cannot read back from the display.

Not used: GPIO4, GPIO17, GPIO18, GPIO27

If you are using the 240x135 1.14" (small rectangular) Mini PiTFT, you can attach other hardware to the Pi on those pins if you use a stacking header - it will go through the 2x12 connector on the Mini PiTFT. This wont work on the 1.3" because the holes don't go through the PCB

TAG: Raspberry Pi 1.44inch LCD display HAT TTL UART To CAN Mini Raspberry Pi CM5 IO BASE B Mini Board a Base Development Platform Compute Module 5 IO Board with EEPROM And Encryption chip SC servo driver Electronic EYE 0.71 inch Round Double LCD Display Dual Screen For Arduino Raspberry Pi ESP32 Pico STM32 Lidar ESP32 1.44inch LCD Supports 6V~24V Solar Panel Modbus POE ETH Relay MQTT User Guide SpotPear Servo RS485 to RJ45 Banana Pi ESP32-S3 0.85inch LCD Raspberry Pi 5 PCIe to M.2 SSD X1201 Raspberry Pi 5 UPS Board Uninterruptible Power Supply For 18650-Li-Battery (NOT includ) DeepSeek XiaoZhi AI Voice Chat Robot BOX ESP32-S3 Development Board 3.5 inch QSPI LCD N16R8 Touchscreen Display 6-Axis /Camera /SD X1009 Raspberry Pi 5 PCIe To 5-Port SATA SATA3.0 (NOT BOOT From SATA) Arduino 1.54inch OLED White