【Product Introduction】

[] 5.79inch E-Paper Display (G), E-Ink Display, 792x272, Red/Yellow/Black/White, SPI Interface

【Product Details】

5.79″ E-Paper (G)

Low Power, Wide Viewing Angle, Paper-Like Effect Without Electricity

Ideal for price tags, shelf labels, industrial instruments...

Note: the driver board is optional, please refer to the Package Content for detailed part list

【Version Options】

【Features At A Glance】

[] No backlight, keeps displaying last content for a long time even when power down

[] Ultra low power consumption, basically power is only required for refreshing

[] Comes with development resources and manual (driver board circuit diagram, examples for Raspberry Pi/Jetson Series/Arduino/STM32)

[] Optional for e-Paper driver board:

[] Adapting SPI interface for connecting with controller boards like Raspberry Pi/Jetson Series/Arduino/STM32, etc.

[] Onboard voltage translator, compatible with 3.3V / 5V MCUs

【Specifications】

OPERATING VOLTAGE	Raw display: 3.3V	DISPLAY COLOR	Red/Yellow/Black/White
	with driver board: 3.3V/5V
INTERFACE	3-wire SPI, 4-wire SPI	GREY SCALE	2
OUTLINE DIMENSIONS	Raw display: 150.92 × 56.94 × 1.00mm	FULL REFRESH TIME	21s
	with driver board: 152.50 × 58.50mm
DISPLAY SIZE	139.00 × 47.74mm	REFRESH POWER	<30mW
DOT PITCH	0.1755 × 0.1755mm	STANDBY CURRENT	<0.01uA (almost none)
RESOLUTION	792 × 272 pixels	VIEWING ANGLE	>170°

Advantages Of EINK

[] E-paper display utilizes microcapsule electrophoretic technology for displaying, the principle is: charged particles suspended in clear fluid will move to sides of microcapsule when electric field is applied, making the microcapsule become visible by reflecting ambient light, just as traditional printed paper.

[] E-paper display will clearly display images/texts under lamplight or natural light, requires no backlight, and features nearly up to 180° viewing angle. It is usually used as e-reader due to its paper-like effect.

Optional For E-Paper Driver Board

Onboard SPI Control Interface, For Use With Controller Boards Like Raspberry Pi/Jetson Series/Arduino/STM32

PWR	Power on/off control
BUSY	Busy status output pin
RST	External reset, low active
DC	Data/Command selection (high for data, low for command)
CS	SPI chip selection, low active
CLK	SPI SCK pin
DIN	SPI MOSI pin
GND	Ground
VCC	Power (3.3V / 5V input)

Onboard Voltage Translator

Compatible With 3.3V / 5V MCUs

Usage Example

Connecting With Raspberry Pi 5

* for reference only, the Raspberry Pi 5 is NOT included.

Supported Driver Boards For Raw Display

【Application Examples】
Suitable For Price Tags, Asset/Equipment Tags, Shelf Labels, Conference Name Tags...

【Outline Dimensions】

[] 5.79inch-e-Paper-G

To：

Dear Customers, There may be a lag of several hours before we could process your order, depending on the time difference between your location and ours. Sincerely hoping your understanding!

Email(support)

services01@spotpear.com