【Note】

[] If you find that the system cannot boot or cannot recognize the hard disk

[] Please check the power supply and whether the spring pin of X1011 is aligned with the chip of Pi5

[] Check the wiring. The FFC cable has a direction. Please check whether the words on the cable are connected correctly;

[] Please update your firmware. Refer to the user manual

【Product Introduction】

[] X1011 is a PCle M.2 NVMe protocol M.2 solid-state drive expansion board designed for Raspberry Pi 5 that can accommodate 4 hard drives. It supports NVMe protocol M.2 interface hard drives, high-speed reading and writing, fast data transfer and ultra-fast booting.

[] X1011 is specially designed to be placed at the bottom of Raspberry Pi 5 without interfering with Raspberry Pi's FPI0, and you can still expand your favorite HAT. In addition, it is fully compatible with the official passive cooler of Raspberry Pi to ensure efficient heat dissipation. The mounting holes and brackets not only protect the solid-state hard drive, but also effectively dissipate heat for reliable performance. The built-in LED light indicates the read or write status.

【Product Details】

【Power supply instructions】

[] 2.5Vdc /-5% ≥ 5A powered by DC power jack

[] 1.5Vdc /-5% ≥ 5A powered by FFC and pogo pins

[] Tip: Do not power X1011 and Raspberry Pi5 at the same time.

Support NVMe hard disk protocol

Supports 4 NVME M2 SSD disks. Supports booting from SSD

【Features】

[] Compatible with other HAT expansion boards;

[] FFC length is only 30mm;

[] Supports installation of official active radiators and also supports third-party radiators;

[] With ACT LED indicator; on: power normal/standby, flashing: read/write;

[] Can accommodate 4 NVMe SSDs. Support SSD boot;

[] Support various M.2 NVMeSSD specifications, including 2280, 2260, 2242 and 2230

[] Equipped with two high-efficiency DC/DC step-down converters with a maximum output of 3.5A3.5A to power your SSD

[] Power the Raspberry Pi through spring feet and FFC to ensure sufficient power supply,

[] Compatible with HAT standby power state, automatically shut down when Pi5 is shut down.

[] Integrated high-performance PCle packet switch

X1011-C1

[] X1011-C1 is a metal case designed for Raspberry Pi 5 and X1011.

[] Note: Due to the metal case, it will interfere with WiFi signals, please use wired Ethernet.

[] X1011

[] X1011-With-Case

To：

Dear Customers, There may be a lag of several hours before we could process your order, depending on the time difference between your location and ours. Sincerely hoping your understanding!

Email(support)

services01@spotpear.com