【Note】

[] X1007 is designed for data storage and does not support booting from HDD/SSD

[] New hard drives do not have partitions and need to be partitioned and formatted on first use before they can be accessed in Explorer.

【Product Introduction】

[] X1007 is a PCIe to dual 2.5-inch SATA HDD/SSD expansion board designed for Raspberry Pi 5.It supports two 2.5-inch SATA HDD/SSDs, providing large-capacity storage and high-speed storage solutions for your Raspberry Pi 5, giving full play to the storage capacity. The SATA 3.0 interface speed can reach up to 5Gbps.

[] X1007 is installed at the bottom of the Raspberry Pi 5, which will not affect the use of GPIO. It is convenient to expand other HATs. In addition, X1007 and the hard disk are powered by the Raspberry Pi 5 through the 4 pins on the board, simplifying the power supply without the need for additional power supplies.

【Product Details】

【Features】

[] Compatible with Raspberry Pi 5B and supports expansion of other HATs for Raspberry Pi;

[] Supports simultaneous connection of two 2.5-inch HDD/SSD;

[] Power from Raspberry Pi 5 via pogo pins;

[] Complies with PCI-Express v2.0 specification and is backward compatible with PCI-Express v1.0

[] Support HAT+STANDBY power state, automatically shut down SATA devices when Pi5 is powered off;

[] Supports communication rates of 5.0 Gbit/s, 3.0 Gbit/s and 1.5 Gbit/s;

[] Compatible with SATA 6G, 3G, 1.5G hard drives;

PCle interface design based

on PI5

Connect to PI5 via FFC cable and power from Raspberry Pi5 via pogo pin.

Support dual hard disks

Can connect two 2.5-inch HDD/SSD at the same time, does not support booting from HDD/SSD using existing firmware

[] X1007

To：

Dear Customers, There may be a lag of several hours before we could process your order, depending on the time difference between your location and ours. Sincerely hoping your understanding!

Email(support)

services01@spotpear.com