【Product introduction】

[] Industry grade USB to TTL serial cable, using the original FT232RNL solution, onboard power supply and signal indicator, support 3.3V/5V level switching, built-in self-recovery fuse, ESD and IO protection diode circuit, etc., small and exquisite, suitable for industrial control equipment serial debugging, You can plug in a Raspberry Pi serial port for debugging.

【Product parameter】

[] Product type: Industrial USB to TTL serial cable

Chip scheme :FTDI original FT232RNL

Host interface :USB

Communication rate :300bps ~ 3Mbps

Device interface :UART

USB interface: Interface type: USB-A interface Protection: self-recovery fuse, ESD electrostatic protection

UART interface: Interface type: 4PIN DuPont wire loose SH1.0 3PIN anti-stay serial port interface Protection: IO protection diode circuit

Indicator :PWR: power indicator. When USB is connected, it is on when voltage is detected. TXD: send indicator. When data is sent from the USB port. RXD: receive indicator

【Original chip solution】

[] Using FT232RNL original chip to provide better stability and compatibility

【Supports Raspberry Pi serial debugging】

[] Applicable to Raspberry Pi, supports a variety of wiring methods can directly connect to the PI5 UART interface through the SH1.0 3PIN interface

[] The UART pin of the Raspberry Pi 40PIN can be accessed via the DuPont wire loose end

[] The above pictures are for display only, this product does not contain Raspberry PI 5

【Multi-system system compatibility】

[] Support Win7/8/8.1/10/11, Mac, Linux, Android and other systems

【Three data indicators】

[] Easily see the working state, for your programming debugging to provide convenience

【Pin specification】

[] VCC: can provide 5V or 3.3V voltage to external equipment (set by switch)

GND: connects to the GND

TXD: Connect to MCU.RXD (signal flow: MCU.RX << FT232 << PC.TX)

RXD: Connect to MCU.TXD (signal flow: MCU.TX >> FT232 >> PC.RX)

【Product size】

[] USB TO TTL (D) × 1

邮箱：services04@spotpear.cn