【Product Details】

[] The EC200U-AU C4-P01 development board is equipped with EC200U-AU LTE Cat 1 wireless communication module, with maximum data rate up to 10 Mbps downlink and 5 Mbps uplink, supports multi-mode & multi-band and is cost-effective. Designed in the compact and unified form factor, compatible with Quectel multi-mode LTE Standard EC20-CE. Onboard Type-C port for easy development with just a USB Type-C cable. Onboard 40PIN GPIO pin header which is compatible with most Raspberry Pi HATs.

【Features At A Glance】

[] Equipped with EC200U-AU LTE Cat 1 wireless communication module, multi-mode & multi-band support

[] Onboard 40PIN GPIO header, compatible with most Raspberry Pi HATs

[] 5 LEDs for indicating module operating status

[] Supports TCP, UDP, PPP, NITZ, PING, FILE, MQTT, NTP, HTTP, HTTPS, SSL, FTP, FTPS, CMUX, MMS protocols, etc.

[] Supports GNSS positioning (GPS, GLONASS, BDS, Galileo, QZSS)

[] Onboard Nano SIM card slot and eSIM card slot, dual card single standby

[] Onboard MIPI connector for connecting MIPI screen and is fully compatible with Raspberry PI peripherals

[] Onboard camera connector, supports customized SPI cameras with a maximum of 300,000 pixels

[] Provides tools such as QPYcom, Thonny IDE plugin, and VSCode plugin, etc. for easy learning and development

[] Comes with online development resources and manual (example in QuecPython)

【Specifications】

【Type-C Interface】

[] Easy To Develop With Just A USB Type-C Cable

【Onboard 40PIN GPIO Header】

[] Compatible With Most Raspberry Pi HATs

【Supports】

[] Provides Tools Such As QPYcom, Thonny IDE Plugin, And VSCode Plugin, Etc. For Easy Learning And Development

【What's Onboard】

[] Onboard Components

1. BG95-M3 module

2. TPS63020DSJR power IC

3. TLV75533PDRVR power IC

4. NCP114AMX180TBG power IC

5. TXS0104EYZTR voltage level translator

6. Nano-SIM card slot

7. NET Network indicator

8. PSM Sleep indicator

9. PWM function indicator

10. PWR Power indicator

11. SIM_CHK indicator

lights up when SIM card is inserted

12. Power ON/OFF button

13. PSM wake-up button

14. BOOT button

Press before powering on to force firmware burning mode

15. USB detection ON/OFF

Normally closed: USB can be connected normally;

Normally open: Type-C supplies power only to the evaluation board, used for module power consumption measurement

[] Interfaces

16. Raspberry Pi GPIO Header

Compatible with Raspberry Pi HATs, for more details, please refer to Pinout Definition

17. Power ON/OFF jumper

Connect: auto turn on, short press PWK button to restart

Disconnect: short press PWK button to power on, long press to power off

18. 1.8V output jumper

Connect: outputs 1.8V externally

Disconnect: used to test power consumption

19. Module power supply jumper

Connect: DCDC to power the module

20. GNSS active power supply selection

Connect: enable GNSS active power supply

21. USB Type-C port

22. Main antenna connector

23. AUX antenna connector

24. GNSS antenna connector

25. Battery power supply header

Supports 2.5V-5.5V battery (Note: the board cannot be powered by USB port and battery at the same time)

【Pinout Definition】

【Outline Dimensions】

[] BG95-M3-Zero x1

To：

Dear Customers, There may be a lag of several hours before we could process your order, depending on the time difference between your location and ours. Sincerely hoping your understanding!

Email(support)

services01@spotpear.com