Pi-1.3inch-LCD-audio-3d User Guide Display

Official image version：

retropie-buster-4.7-xxxx.img

Board version：Raspberry Ri Zero/Zero 2/3B/4B/CM4

Raspberry Pi have updated their official image to bullseye version, We have tested the fbcp-ili9341 driver from https://github.com/juj/fbcp-ili9341 still can not support the bullseye image.
Retropie still is buster,the fbcp-ili9341 driver can work at Retropie-4.7.
But we can not make sure whether the fbcp-ili9341 will support the updated bullseye Retropie In the future.

The 1.54 inch LCD Hat can run 60fps with the fbcp-ili9341 driver

sudo nano /boot/config.txt
Add this code
hdmi_force_hotplug=1

Then reboot
Download fbcp-ili9341 to your pi
git clone https://github.com/juj/fbcp-ili9341.git 
(Make sure that you download fbcp-ili9341 under path /home/pi/)
cd fbcp-ili9341

sudo mkdir build

cd build

sudo cmake -DWAVESHARE_ST7789VW_HAT=ON -DGPIO_TFT_DATA_CONTROL=22 -DGPIO_TFT_RESET_PIN=27 -DSPI_BUS_CLOCK_DIVISOR=6 -DSTATISTICS=number ..
If all work well，you will get this following picture

sudo make -j
If all work well，you will get this following picture

Run the display driver using ：
sudo ./fbcp-ili9341
Then your LCD will display well, but the Fontsize is too small
Change the LCD display resolution

sudo nano /boot/config.txt

Add the following code

hdmi_group=2

hdmi_mode=1

hdmi_mode=87

hdmi_cvt 480 480 60 6 0 0 0

display_rotate=0

avoid_warnings=1

If use the LCD with 3D-Prism, Need to add the extra configured code：

Make fbcp-ili9341 work automatically when your Pi boot

sudo nano /etc/rc.local
Add the following code
sudo /home/pi/fbcp-ili9341/build/fbcp-ili9341 &

sudo reboot 
After your Pi reboot,Your LCD will display well