【Note】

[] The current you need depends on the startup current of the HDD you use (the startup current will be larger than the working current). You need to check the startup current of the HDD you use to determine the maximum current of the power adapter you will use.

[] Even if the power supply capacity of X1009 is not enough, you can also use other power supplies to power the HDD.

[] Conclusion: How many HDDs can be used depends on the power supply capacity. You can try more to test it.

【Product Introduction】

[] X1009 is a PCIe to PCIe to 5-port SATA expansion board designed for Raspberry Pi 5. It supports simultaneous connection of 5 large-capacity SATA storage devices, and the SATA3.0 interface speed can reach up to 5Gbps. Provide large-capacity storage and high-speed transmission for your Raspberry Pi 5, giving full play to the storage capacity of Raspberry Pi.

[] X1009 has a standard DC jack 12V input on board and is equipped with an efficient DC/DC step-down converter, which can power Raspberry Pi 5 and PCle devices at the same time.

[] We have tested 4 3.5-inch HDDs + 1 2.5-inch HDD, and the current required during the test was about 6A.

【Product Details】

[] X1009

[] X1009-With-Power

[] X1009-With-Power-Case

To：

Dear Customers, There may be a lag of several hours before we could process your order, depending on the time difference between your location and ours. Sincerely hoping your understanding!

Email(support)

services01@spotpear.com