KEIL Development Environment Configuration

[] 1.Open the program using KEIL software. Follow the steps in the images, selecting steps one, two, and three sequentially.

[] 2.As shown in the diagram below, the Utilities interface also needs to select “CMSIS-DAP Debugger.”

[] 3.Detailed configuration:

For “1,” select “SW” mode instead of JTAG.

For “2,” the maximum download speed is 10Mbps. If the download cable is too long or there is poor contact, it may lead to programming failure. Please reduce the download speed.

For “3,” select “Autodetect” for automatic detection.

For “4,” if a series of numbers and letters appears, it indicates that the microcontroller has been detected.

[] 4.Click on “Program” to start programming. The progress bar at the bottom will display the programming progress, and it will be completed quickly.

To：

Dear Customers, There may be a lag of several hours before we could process your order, depending on the time difference between your location and ours. Sincerely hoping your understanding!

Email(support)

services01@spotpear.com

TAG： Raspberry Pi 5 Power Raspberry Pi 5 IMX219 ESP32 S3 Development Board 1.75 inch AMOLED Display TouchScreen SD slot 6-axis sensor Xiaozhi AI Deepseek Jetson Nano Expansion Board Raspberry Pi 5 RTC Box Raspberry Pi ZERO Milk-V Duo HUB ESP32-P4 DEV-KIT C6 WiFi6 MIPI DSI 7/10.1 inch Display/CSI Camera/Audio Speaker For AI Deepseek ESP32 S3 AI 1.75 inch Development Board with 1.75inch AMOLED Touchscreen Round Screen Deepseek Raspberry Pi Refractive Prism ESP32-S3 2.16inch AMOLED Display AI Development Board 480×480 2.16 inch TouchScreen Deepseek Arduino MLX90640 SpotPear Industrial Modbus POE ETH RJ45 To Relay 30CH RTU/Modbus TCP-Ethernet For IOT Allwinner ESP32 Raspberry Pi 5 Jetson Raspberry Pi 64MP Camera ESP32-S3 DeepSeek AI Box Robot Development Board N16R8 Toy Doll Option 0.71 inch Electronic Eyes

KEIL Development Environment Configuration

To：

Email(support)

DAPLINK emulator replaces JLINK OB/STLINK STM32 programmer and downloader