Overview

Introduction

This is a 2.4G/5GHz Dual Band WiFi5 Generation wireless module and supports Bluetooth 5.0 standard and low-power consumption. It also features low latency and is compatible with IEEE 802.11ac/m MIMO OFDM wireless technology, with two transmission paths and two reception paths.

Features

• Supports 2.4G/5GHz dual-band, the frequency is 574Mbps in the 2.4GHz band and 1200Mbps in the 5GHz band
• Supports Bluetooth 5.2 standard, compatible with Bluetooth 2.1+EDR
• Adopts MiniPCIe interface
• Supports 802.11ac/ax 2×2 Wave-2 MU-MIMO
• Support Linux, Windows 10/11 and other operating systems

Precautions

• 1. Technical support is currently only available for Jetson series motherboards
• 2. Only Linux kernel version 5.10 or higher is supported
• 3. Only Windows 10/11 are supported, and other Windows versions are not supported

Usage Instructions

Raspberry Pi 5 / CM5

sudo apt install -y dkms build-essential bc git
git clone https://github.com/lwfinger/rtw89.git
cd rtw89
make -j4
sudo make install
#Add dtoverlay=pcie-32bit-dma-pi5 to the end of the config.txt
sudo nano /boot/firmware/config.txt
#Save, exit, and reboot
sudo reboot
#Check WiFi
ifconfig -a

Debug and use:

#Start the module (only use the test after installation, and it will start automatically after restarting)
sudo modprobe rtw_8822ce
#Check driver status
dmesg | grep rtw
lsmod | grep rtw

Support

Monday-Friday (9:30-6:30) Saturday (9:30-5:30)

Email: services01@spotpear.com