1] Make sure the camera is properly connected to the hardware, and then power on the device：

The system will automatically detect the camera. If you are unable to connect to the camera during the following operations, you will need to log in to the system terminal and use the command "ls /userdata" to check if the system recognizes it. If the camera is recognized, there will be an "rkipc.ini" file; otherwise, the file will not exist；

2] Get device IP：

(Translation: The Plus-Pico can use Ethernet and RNDIS, while the Pico uses RNDIS to connect to the camera.)

Translation: After logging into the system terminal using either serial port or ADB, you can use the “ifconfig” command to view the IP address.

Translation: The IP address displayed by “eth0” is for the Plus-Pico network interface, while the IP address displayed by “usb0” is for RNDIS.

3] Open the network streaming function in VLC:

4] Connect the camera using RNDIS：

5] Connect the camera using an Ethernet port：

When testing the camera, you can try to have a person’s face appear in the frame. This board supports facial recognition functionality.

TAG： LuckFox Pico User Guide Raspberry Pi Raspberry Pi 3 LCD HAT Raspberry Pi 3D Display Arduino 0.96inch RGB OLED Bus Servo DC-BUCK-Adapter 7.2V Voltage mini module For SC15/SC09 Servo Raspberry Pi 5 Camera User Guide ESP32 S3 4.3inch LCD (B) 800x480 Captive TouchScreen Display Board LVGL with Sensor CAN I2C RS485 WiFi6 ESP32 Thermal imaging camera RV1103 Wiki Arduino Thermal imaging camera SpotPear luckfox-pico-ultra-w-WIFI-Bluetooth Pi5-Active-Cooler-C ESP32-S3 LCD 1.54inch OLED 3D Display Transparent Screen Cortex-A53

Luckfox Pico RV1103【Connect to SC3336-camera for network streaming】

【First-level Agency】LuckFox Pico Linux RV1103 Rockchip AI Board ARM better than Raspberry Pi Pico