• sales

    +86-0755-88291180

Run Arduino Demo in spi model

Overview

When we directly connected the SPI display module without the on-board level conversion module to the Arduino,

we found that it could not run at all.This is because the SPI module's pin can only input a 3.3V high level,

while the Arduino output has a high level of 5V.

To run successfully, there are two Method: short circuit method and external level conversion module method.

The short-circuit method has the advantages of simple operation, short wiring, and no need for external devices.

The disadvantage is that the module generates a large amount of heat during operation.

Will affect the life of the module.

The external level conversion module method is a normal operation, and the advantage is that the module generates

less heat and runs stably during operation, and the disadvantage is that the operation is slightly complicated.

(An external level shifting module is required) to increase the cost (additional level conversion module is required).

In summary, it is recommended to use the external level shifting module method.

Short-Circuit Method

The short-circuit method is to short the J1 component position (shown below) with solder on the back of the module.

After shorting, the runtime module VCC The pin must be connected to a 5V power supply (not connected to 3.3V).


External Level Conversion Module Method

The so-called external level conversion module method is to connect the Arduino and the display module

through an external level conversion module, so that The 5V high level of the Arduino output is converted

to 3.3V by the level conversion module and then input to the display module. As shown below:


TAG: Raspberry Pi 15.6 inch FHD Monitor (C) LCD 1080P Capacitive TouchScreen Display Type-C/HDMI For Computer PC Raspberry Pi WatchDog ESP32 LVGL Industrial RJ45 Ethernet To 16-ch Relay Module Modbus RTU TCP With Protection and guide rails ESP32 IR Thermal Imaging Camera ESP32-C3FN4 Arduino-check-library-path Raspberry Pi 5 DSI User Guide Raspberry Pi RP2040 Long-Rang ESP32-S3 Development Board 3.16 inch LCD display 3.16inch Screen SD slot 320x820 RGB LED ST7701 Arduino 1.5inch LCD ESP32 S3 5 inch LCD Development Board 800x480 TouchScreen Display TVBOX LVGL HMI Sensor CAN RS485 ESP32-S3 1.28inch LCD Intel 12th Industrial Modbus RTU RS485 8-ch 30A High Current Relay Module (E) With Digital Input CAN FD Analyzer 1.54 inch Passive NFC e-Paper BW Display E-ink Screen No Need Battery Wireless Powered & Data Transfer Jetson Nano DeepSeek AI Voice Chat ESP32 S3 Development Board 1.8 inch AMOLED Display 368×448 1.8inch TouchScreen Programmable Watch QMI8658 /MIC /Audio /Battery RS485 TO Relay