7.3nch four color e Paper e Ink Display Module SPI for Arduino / STM32 / Jetson Nano / Raspberry Pi

7.3nch four color e Paper e Ink Display Module SPI for Arduino / STM32 / Jetson Nano / Raspberry Pi

$55.89

Brand：Spotpear

SKU：0201154

Date：2022-08-09 16:33

Part Number：

7.3inch-e-Paper-(G) 7.3inch-e-Paper-HAT-(G)

No：

- +

In Stock

Buy It Now

Add to cart

Ask a Question

Copy Link

7.3nch four-color e-Paper e-Ink Display Module SPI for Arduino / STM32 / Jetson Nano / Raspberry Pi

7.3 e-Paper

7.3inch e-Paper (G)

7.3inch e-Paper (E)

7.3inch e-Paper (F)

Note: Do not include Raspberry Pi and Jeston Nano, Please Buy alone.

Features

No backlight, keeps displaying last content for a long time even when power down
Ultra low power consumption, basically power is only required for refreshing
SPI interface, for connecting with controller
boards like Raspberry Pi / Jetson Nano / Arduino / STM32, etc.
Onboard Level conversion chip, compatible with 3.3V / 5V Level interface
Comes with development resources and manual
(driver board circuit diagram, examples for Raspberry Pi / Arduino / STM32)

Specifications

Size: 7.3inch
Outline dimension: 170.2 × 111.2 mm
Display size: 160 × 96 mm
Operating voltage: 3.3V/5V
Interface: 3-wire SPI、4-wire SPI
Display color: Red, Yellow, Black , White
Gray scale: 2
Full refresh time: 16 s
Refresh power: < 85 mW(typ.)
Standby current: < 0.01 uA (close to 0)
Dot pitch: 0.2 × 0.2 mm
Resolution: 800 × 480 pixels
Viewing angle: >170°

Advantages Of EINK

E-Paper Display Utilizes Microcapsule Electrophoretic Technology For Displaying, The Principle Is: Charged Particles Suspended In Clear Fluid Will Move To Sides Of Microcapsule When Electric Field Is Applied, Making The Microcapsule Become Visible By Reflecting Ambient Light, Just As Traditional Printed Paper.
E-Paper Display Will Clearly Display Images/Texts Under Lamplight Or Natural Light, Requires No Backlight, And Features Nearly Up To 180° Viewing Angle. It Is Usually Used As E-Reader Due To Its Paper-Like Effect.

Raspberry Pi 40PIN GPIO Compatibility

Designed For Raspberry Pi Boards / Jetson Nano

SPI Control Interface

For Use With Controller Boards Like Raspberry Pi / Jetson Nano / Arduino / STM32

VCC	3.3V / 5V
GND	GND
DIN	SPI MOSI pin
CLK	SPI SCK pin
CS	SPI chip select pin (active low)
DC	Data/command control pin (high for data, low for command)
RST	External reset pin (low reset)
BUSY	Busy state output pin