【Overview】

[] 4.26″ E-Paper HAT：Low Power, Wide Viewing Angle, Paper-Like Effect Without Electricity. Ideal for price tags, shelf labels, industrial instruments...

【Features】

[] No backlight, keeps displaying last content for a long time even when power down

[] Ultra low power consumption, basically power is only required for refreshing

[] Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards

[] SPI interface, for connecting with other controller boards like Raspberry Pi/Jetson Nano/Arduino/STM32, etc.

[] Onboard voltage translator, compatible with 3.3V/5V MCUs

[] Comes with online development resources and manual (driver board circuit diagram, examples for Raspberry Pi/Jetson Nano/Arduino/STM32)

【Specifications】

[] OPERATING VOLTAGE：3.3V/5V

[] DISPLAY COLOR：Black/White

[] INTERFACE：3-wire SPI, 4-wire SPI

[] GREY SCALE：4

[] OUTLINE DIMENSIONS：107 × 64mm

[] FULL REFRESH TIME：4s

[] DISPLAY SIZE：92.80 × 55.68mm

[] PARTIAL REFRESH TIME：0.7s

[] DOT PITCH：0.116 × 0.116mm

[] REFRESH POWER：<35mW

[] VIEWING ANGLE：>170°

[] STANDBY CURRENT：<0.01uA (almost none)

[] RESOLUTION：800 × 480 pixels

【Advantages Of EINK】

[] E-paper display utilizes microcapsule electrophoretic technology for displaying, the principle is: charged particles suspended in clear fluid will move to sides of microcapsule when electric field is applied, making the microcapsule become visible by reflecting ambient light, just as traditional printed paper.

[] E-paper display will clearly display images/texts under lamplight or natural light, requires no backlight, and features nearly up to 180° viewing angle. It is usually used as e-reader due to its paper-like effect.

【Standard Raspberry Pi 40PIN GPIO Header】

[] Compatible With Raspberry Pi Series Boards

Note：for reference only, the Raspberry Pi in the picture is NOT included

【Onboard SPI Control Interface】

[] For Use With Controller Boards Like Raspberry Pi/Jetson Nano/Arduino/STM32

[] PWR：Power on/off control

[] BUSY：Busy status output pin

[] RST：External reset, low active

[] DC：Data/Command selection (high for data, low for command)

[] CS：SPI chip selection, low active

[] CLK：SPI SCK pin

[] DIN：SPI MOSI pin

[] GND：Ground

[] VCC：Power (3.3V / 5V input)

【Dimensions】

[] 4.26inch-e-Paper-HAT

1. 4.26inch e-Paper HAT x1

2. GH1.25 9PIN cable 20cm x1

3. Screws pack x1

To：

Dear Customers, There may be a lag of several hours before we could process your order, depending on the time difference between your location and ours. Sincerely hoping your understanding!

Email(support)

services01@spotpear.com