pre configured images not working

Hello, our pre-configured image can be used directly after burning. It takes a little time to boot up, please wait.

1.DietPi Retro 64bit Bullseye image does not support Pi Zero, it only supports Pi Zero 2W.

2.Pi Zero can only use this image: Gampi154-retropie-4.7.19-rpi1_zero-211209.

3.Where is the terminal prompt displayed? Is it on the HDMI display or on the Gampi154 screen?

4.How to connect the Raspberry Pi and display screen? Often, customers do not connect them properly, or the GPIO pins on the Raspberry Pi might be damaged, causing no display.

5.How to solder the header pins on the back? Some customers have issues because the header pins were not soldered correctly, leading to GPIO driver problems and no display.

6.Has your Raspberry Pi Zero been used for a long time? If it has been used for a long time, it could be that the GPIO pins are damaged, causing the display issue.

ok, so you were right! I have put Gampi154-retropie-4.7.19-rpi1_zero-211209 back on and waited and waited and waited and sure enough the menu came up!

now another issue-  I can only get to the menu.  it goes left and right to select between the nintendo icon and retropie  but I cannot select anything.  If I hit "start" it goes into configuration menu and I can move the selection up and down but I also cannot select anything.

I tried every button and no response.  If I hit "select" the screen dims a bit but just sits there

ok so in the end i discovered gpio 38 & 40 to be faulty on my zero, that is why A & B buttons were not working. (I remapped and everything works fine, lost two buttons) My solution now is to  jumper 38 & 40 to 26 & 27 and update the firmware to use those pins instead.