• sales

    +86-0755-88291180

Dont work on raspberry pi 4

2025-06-29 18:31:12 Ask

On raspberry pi 4b rev 1.1 audremap conflicts:

[    3.329725] pinctrl-bcm2835 fe200000.gpio: pin gpio18 already requested by fe00b840.mailbox; cannot claim for fe203000.i2s

[    3.329744] pinctrl-bcm2835 fe200000.gpio: error -EINVAL: pin-18 (fe203000.i2s)

[    3.329752] pinctrl-bcm2835 fe200000.gpio: error -EINVAL: could not request pin 18 (gpio18) from group gpio18 on device pinctrl-bcm2711

[    3.329758] bcm2835-i2s fe203000.i2s: Error applying setting, reverse things back


in my config.txt

# For more options and information see

# http://rptl.io/configtxt

# Some settings may impact device functionality. See link above for details


# Uncomment some or all of these to enable the optional hardware interfaces

dtparam=i2c_arm=on

dtparam=i2s=on

dtparam=spi=on


# Enable audio (loads snd_bcm2835)

dtparam=audio=off


# Additional overlays and parameters are documented

# /boot/firmware/overlays/README


# Automatically load overlays for detected cameras

camera_auto_detect=1


# Automatically load overlays for detected DSI displays

display_auto_detect=1


# Automatically load initramfs files, if found

auto_initramfs=1


# Enable DRM VC4 V3D driver

dtoverlay=vc4-kms-v3d

max_framebuffers=2


# Don't have the firmware create an initial video= setting in cmdline.txt.

# Use the kernel's default instead.

disable_fw_kms_setup=1


# Run in 64-bit mode

arm_64bit=1


# Disable compensation for displays with overscan

disable_overscan=1


# Run as fast as firmware / board allows

arm_boost=1


[cm4]

# Enable host mode on the 2711 built-in XHCI USB controller.

# This line should be removed if the legacy DWC2 controller is required

# (e.g. for USB device mode) or if USB support is not required.

otg_mode=1


[cm5]

dtoverlay=dwc2,dr_mode=host


[all]

# Habilitamos el hat de audio

dtoverlay=audremap,pins_18_19

0answers
Price: $8.59/12.89
Part Number: Audio-Module-(B)
Brand: Spotpear